Service Information and Revisions
RV-12iS Revisions and Changes
Note: The date in a document’s title will not be the same as the date on which the document is posted. Drawing date represents the date the change was proposed/started. Date posted represents the completion/release date. Some revisions take longer than others to complete. Reasons include complexity, discovery of additional items needing revision, dependencies on other changes, validation/testing, parts fabrication, etc.
Document Key:
KAI = Kit Assembly Instructions (Number in title indicates the plans section number)
MM = Maintenance Manual
POH = Pilot Operating Handbook
PAP = Production Acceptance Procedures
FTS = Flight Training Supplement
ID
Date Posted
Applies To
Description
Details
ID
01iS/U
Date Posted
October 1, 2019
Applies To
RV-12iS
Description
Update for Garmin IFR avionics kit option
ID
03iS/U 02
Date Posted
February 14, 2019
Applies To
RV-12iS
Description
Changes Made, Page 02
ID
04iS/U
Date Posted
November 6, 2020
Applies To
RV-12iS
Description
Section 4 for RV-12iS - Parts Index update
ID
10iS-U
Date Posted
November 24, 2021
Applies To
RV-12 and RV-12iS
Description
Reflects change to tie-down blocks, which are now shipped with the threads already tapped.
ID
11iS-U
Date Posted
October 6, 2020
Applies To
RV-12 and RV-12iS
Description
Added instructions to ensure threadlock fluid is properly applied and to test-run servo before installation.
ID
12
Date Posted
December 17, 2018
Applies To
All RV-12/12iS aircraft with Finish Kits shipped prior to 02/05/2019
Description
Changes Made
ID
12iS/U
Date Posted
October 1, 2019
Applies To
All RV-12/12iS aircraft with Finish Kits shipped on or after 02/05/2019
Description
Update for Garmin IFR avionics kit option
ID
13
Date Posted
November 24, 2021
Applies To
RV-12 and RV-12iS
Description
Reflects change to tie-down blocks, which are now shipped with the threads already tapped.
ID
17
Date Posted
December 17, 2018
Applies To
All RV-12/12iS aircraft
Description
Changes Made: Page 17-02
ID
23iS/U
Date Posted
November 21, 2019
Applies To
RV-12iS
Description
Added drawings and instructions for installation of new vent knob (Order P/N 'BAG 3116' to receive components needed to add to existing vents)
ID
27iS
Date Posted
May 14, 2020
Applies To
RV-12iS
Description
Changed fuel system sealing washer
ID
28iS/U
Date Posted
February 14, 2019
Applies To
RV-12iS
Description
Updated for gun-drilled gear legs
ID
29iS/U
Date Posted
March 7, 2019
Applies To
RV-12iS
Description
Changes Made to order of egress handle assembly step, minor hardware adjustment.
ID
35iS/U
Date Posted
December 2, 2021
Applies To
RV-12iS
Description
Changes to install sequence for upper 90-degree fitting on gun-drilled gear legs.
ID
36iS/U
Date Posted
November 10, 2020
Applies To
RV-12 and RV-12iS (all, optional)
Description
Updated to reflect available Grove wheels and brakes option
ID
37iS/U
Date Posted
December 22, 2020
Applies To
RV-12iS
Description
Changes related to new oil door bushing and parts
ID
37iS/U
Date Posted
May 10, 2018
Applies To
RV-12iS
Description
Changes Made Superceded by version posted 12/17/2018
ID
38iS/U
Date Posted
November 24, 2021
Applies To
RV-12iS
Description
Changes Made related to the necessary installation of wing root gap seal before flight.
ID
40iS-U
Date Posted
May 5, 2020
Applies To
RV-12iS
Description
Minor changes made to harness part number call-out
ID
42CiS/U
Date Posted
January 22, 2021
Applies To
RV-12iS
Description
Changes related to B&C voltage regulator
ID
42MiS/U
Date Posted
April 22, 2021
Applies To
RV-12iS
Description
Change to shorter wire pass-through snap bushings in center section
ID
42NiS
Date Posted
October 6, 2020
Applies To
RV-12iS
Description
Wiring harness change related to Garmin GMC 507 Autopilot Control Module
ID
42PiS_12iS
Date Posted
October 6, 2020
Applies To
RV-12iS
Description
Updated with changes related to GTN 650 rev
ID
44BiS
Date Posted
October 6, 2020
Applies To
RV-12iS
Description
Replaced Garmin GMC 307 with Garmin GMC 507 Autopilot Control Module (Garmin Automatic Flight Control System (AFCS) Mode Controller).
ID
46iS
Date Posted
March 17, 2021
Applies To
RV-12iS with Rotax 912 iS engine
Description
Change to starter cable part number: WH-P158 replaces WH-P155.
ID
46U
Date Posted
January 22, 2021
Applies To
RV-12iS with ULS engine
Description
Changes related to B&C voltage regulator
ID
47AiS/U
Date Posted
February 3, 2020
Applies To
RV-12 and RV-12iS (all, optional)
Description
New section - covers the installation of an optional three-blade Sensenich propeller on RV-12 or RV-12iS. See also Service Letter SL 19-12-31.
ID
48iS-U
Date Posted
May 6, 2021
Applies To
RV=12iS
Description
Reflects improved design for the cylinder #1 & #2 exhaust assemblies. Updated instructions.
ID
49U
Date Posted
October 6, 2020
Applies To
RV-12iS
Description
Changes made related to new throttle return spring retainer part for ULS engine only
ID
50iS/U
Date Posted
May 6, 2021
Applies To
RV-12iS
Description
Added information to assembly instructions to help ensure exhaust clearance to coolant hoses; Improved instructions.
ID
53AiS/U
Date Posted
March 7, 2019
Applies To
RV-12iS with Dynon ADS-B In not already installed
Description
Change to spacer and assembly instructions
ID
53BiS/U
Date Posted
October 6, 2020
Applies To
RV-12iS with Garmin ADS-B In not already installed
Description
Updated with changes related to wiring harness callout
ID
55iS/U
Date Posted
October 21, 2019
Applies To
RV-12iS
Description
New section: Oil Cooler Winterization Kit for the RV-12iS (optional)
ID
MM RV-12iS
Date Posted
February 26, 2021
Applies To
RV-12iS
Description
Updated to v3.7, revises inspection schedule for Fuel Tank Finger Strainer and AOA System testing information.
