Includes changes related to change from 4″ to 5″ oil cooler tube.
-
09/23/2020
REVISION DESCRIPTION:
KAI Page 47-01 REV 1: “CB-00015A RIGHT AFT BAFFLE” was “CB-00015 RIGHT AFT BAFFLE”, “CB-00037 5” FLANGED DUCT” was “VA-187 4” FLANGED DUCT”.
KAI Page 47-04 REV 1: In Step 1, “…CB-00015A…” was “CB-00015”.
In Step 8, “Cleco, then rivet the CB-00037 5” Flanged Duct to the right aft baffle as shown.” was “Center, then clamp, the VA-187 4” Flanged Duct to the large hole in the right aft baffle.”
Deleted Steps 9-11.
In Figure 1, CB-00015A was CB-00015. CB-00037 was VA-187. “7X AN470AD4-4 was 6X AN470AD4-4”. Added “DO NOT RIVET callout.
KAI Page 47-05 REV 1: In Step 3, “…CB-00015A…” was “…CB-00015…”.
In Figure 1, “CB-00015A” was “CB-00015”, “4X AN470AD4-4” was “8X AN470AD4-4”, added “4X AN470AD4-4.5” callout.
KAI Page 47-07 REV 1: In Step 1, added “Allow the RTV to fully cure before installing the baffles.
Figures 2 and 3 updated to depict CB-00015A.
KAI Page 47-12 REV 1: In Step 1, added “Allow the RTV to fully cure before installing the baffles”.
KAI Page 47-13 REV 1: Figure 1 updated to depict CB-00015A.
KAI Page 47-14 REV 1: In Step 5, “Fabricate one or more CB-00038 Tension Rod Tubes…” was “Fabricate one or more CB-00037 Tension Rod Tubes…”
In Figure 1, “CB-00038” was “CB-00037”
