PAP RV-12iS RV-12iS Production Acceptance Procedures (PAP)

Updated to Rev 2.5

Changelog

• 04/08/2024

  RV-12iS PAP REV 2.5:

  Section G1:

  • Added canopy latch check with non-dominant hand

  Section G2:

  • TAKEOFF trim measurement is 2-3/16”, was 2”
  • Added control check for flaps down condition
  • Rudder travel tolerance is 1/4”, was 1/8”
  • Added check of degrees of rudder travel
• 01/17/2022

  RV-12iS PAP REV 2.4:

  Added wing root gap seal to section G10.

• 10/30/2020

  RV-12iS PAP REV 2.3:

  On Page G6-2: rephrased to allow the prop balance to be completed within 15 hours of first flight.

• 10/06/2020

  RV-12iS PAP REV 2.2:

  • Clarified that cooling fans should move air in opposite directions on page G1-1.
  • Replaced “torquing” with “tightening” for radiator pipe plug install on page G4-1.
  • Replaced GTN 650 with GTN 650Xi on page F4-3.